1.Large flat glass non-structural engineering
2.Bonding, caulking and sealing of various small glass doors
3.All kinds of doors, windows, aquariums, etc. installation, bonding, caulking and sealing, and indoor glass decoration bonding and sealing
1.Cannot be used as structural adhesive
2.Not suitable for use on the surface of the substrate containing oil or oozing grease, plasticizer or solvent
3.Not suitable for frosted or wet substrate surface
4.Not suitable for airtight places and places where the surface temperature is lower than 6°C or higher than 40°C
1.Before use, the relevant substrate must be tested for compatibility and adhesion
2.The construction site must maintain a good ventilation environment
3.The user should strictly abide by the construction specifications during the construction process
4.Uncured glue should not be in contact with the skin for a long time. If it gets into the eyes accidentally, rinse with plenty of water and seek medical attention if necessary
5.This product is strictly forbidden to eat, it is strictly forbidden to be checked into the body, and avoid children's contact
|
NO. |
Item |
Standard regulations |
Test result |
Individual evaluation |
||
|
1 |
Appearance |
It should be a fine, uniform paste without lumps Gel crusts and precipitates that are not easy to disperse quickly |
Fine and uniform black paste, no agglomerated gel, crust and precipitates that are not easy to disperse quickly |
Qualified |
||
|
2 |
Sagging degree, mm |
Vertical placement |
≤3
|
0 |
Qualified |
|
|
Horizontally |
Not deformed |
Not deformed |
||||
|
3 |
Density/g/cm3 |
Specified value ±0.1 |
0.98 |
Measured value |
||
|
4 |
Hardness/shore A |
15-50 |
26 |
Qualified |
||
|
5 |
Surface drying time/h |
≤2 |
0.1-0.3 |
Qualified |
||
|
6 |
Tensile adhesion |
Standard condition |
Tensile bonding strength/MPA |
≥0.20 |
0.4 |
Qualified |
|
Bonding failure area/% |
≤15 |
0 |
Qualified |
|||
|
After soaking |
Tensile bonding strength/MPA |
≥0.20 |
0.3 |
Qualified |
||
|
Bonding failure area/% |
≤15 |
0 |
Qualified |
|||
|
7 |
Extrude ability/(ml/min) |
≥110 |
460 |
Qualified |
||